Designed specifically for automotive, military and aerospace BCI EMC testing, this mismatch tolerant Class A amplifier delivers power continuously into the varying match typically associated with this type of testing.
The Class A design ensures a high reliability, low distortion linear performance across the frequency range. This design also ensures that the amplifier will continue to operate at full power even when presented with an open or short circuit at its output.
The unit is powered from a switched mode power supply for high efficiency, high power factor and wide voltage range operation. The unit is air-cooled with integral fans, and is protected against faulty cooling by excess temperature sensing. A safety interlock connector is provided, which the user can short circuit to ground, to put the amplifi er into standby mode. Front panel indicators are provided to indicate over-temperature and rf interlock operation.
|Frequency range (instantaneous)||
10 kHz to 400 MHz
|Rated output power||
110 W minimum
|Output power at 1 dB gain compression||
80 W minimum (110 W typical below 100 MHz)
|Harmonics at P1 dB||
|Power Supply Voltage||
|Power Supply Phases||
AMETEK CTS GmbH
4153 Reinach, Switzerland
Tel.+ 41 61 204 41 00
Astrid Wälchli Schreiber
Register of companies: CH-280.4.015.069-3